Warranty; Conformity Declaration; Description Of Symbols - Phonak Profilo WL-Kit DM User Manual

6 Warranty

The duration of the warranty for defects in parts or workmanship is two years from the date of
purchase. Any responsibility for incidental or consequential damages will be refused.
This warranty does not cover damage from improper handling or care, exposure to chemicals,
immersion in water or undue stress.
Damage caused by third parties or non-authorized service centers renders the warranty null
and void.

7 Conformity declaration

Hereby, Phonak Communications AG, Langgasse 17, CH-3280 Murten, declares that these
Phonak products are in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. To obtain a copy of the Declaration of conformity, please
contact the manufacturer or the local Phonak representative whose address can be taken from
the list on www.phonak.com (worldwide locations).
This device complies with Part 15 of the FCC Rules and with RSS210 of Industry Canada.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation. The device has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. The
device generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
20
7 Conformity declaration
However, there is no guarantee that interference will not occur in a particular installation.
If the device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the
interference by one of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the device and receiver.
– Connect the device into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the device.

8 Description of symbols

This symbol on the product or its packaging means that it should not be disposed of with
your other household waste. It is your responsibility to hand over your old appliance to
the applicable collection point for the recycling of electrical and electronic equipment. The
correct disposal of your old appliance will help prevent potential negative consequences
for the environment and human health.
This symbol indicates that it is important for the user to pay attention to the relevant
warning notices in this user guide.
21