Phonak ROGER EARPIECE User Manual
Hide thumbs Also See for ROGER EARPIECE:

Advertisement

Roger
Earpiece
TM
User Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ROGER EARPIECE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Phonak ROGER EARPIECE

  • Page 1 Roger Earpiece User Guide...
  • Page 2: Table Of Contents

    Contents Welcome Special functions System description Incoming audio signal detection Roger for Studio system Mute Getting to know your Roger Earpiece Out of range In the box Sleep mode Device descriptions Battery end of life Battery technology Adding additional versatile microphone...
  • Page 3: Welcome

    2 System description Roger for studio illustrations 2.1 Roger Earpiece communication system Congratulations on choosing the Roger Earpiece from Phonak Communications AG. Used with the Roger BaseStation, this ultra-miniaturized receiver uses adaptive wireless transmission to allow people to receive audio information discreetly.
  • Page 4: Getting To Know Your Roger Earpiece

    … 0-10 cm 0-4 inches 0-10 cm 3 Getting to know your 0-4 inches Roger Earpiece 3.2 Device description se battery door 2.6 Connect with Base Station 2.7 Insert Earpiece in ear 2.8 Remove Earpiece 3.1 Box contents door 2.6 Connect with Base Station 2.7 Insert Earpiece in ear...
  • Page 5: Battery Technology

    3.3 Battery technology 3.5 Meaning of beeps The Roger Earpiece uses a Zinc Air battery because Start-up it offers the most energy in the smallest size. Einschalten Zinc Air batteries use air to produce current, and a tab Démarrage seals the air holes on the battery prior to use. Once...
  • Page 6: Getting Started

    • When the Roger Earpiece is not in use, it is recommended to completely open the battery door to turn the device off. However please note that the battery...
  • Page 7: Using Roger Earpiece

    0-4 inches 0-10 cm 0-10 cm 0-4 inches 0-4 inches Only one Roger Earpiece can be connected at a time. Keep 0-10 cm 0-4 inches any other Roger devices out of range during this process. 2.6 Connect with Base Station 2.7 Insert Earpiece in ear...
  • Page 8: How To Adjust Volume Of A Single

    - The cerumen filter system is provided with Roger Earpiece You can adjust the volume of a single Roger Earpiece with • Clean the Roger Earpiece’s entire surface and the green the help of a Roger Touchscreen Mic. Refer to the Roger wax guard with Phonak cleaning spray and leave wet Touchscreen Mic user guide for more information.
  • Page 9: Special Functions

    2.35 Exchange wax filter 2.35 Exchange wax filter wax guard is correctly If the Roger Earpiece is out of range for less than 30 in place. Roger Earpiece minutes before coming back into range, the Roger is ready to use.
  • Page 10: Sleep Mode

    7 Troubleshooting 6.4 Sleep mode The Roger Earpiece doesn’t Solutions The Roger Earpiece will enter sleep mode after 30 minutes switch on if no Roger transmitter is in range during this time. The battery is empty Change the battery In sleep mode the Roger Earpiece will continue to search...
  • Page 11 The Roger Earpiece is Solutions continuously beeping The volume is too low Solutions The Roger Earpiece is out Move closer to Roger BaseStation of range of Roger BaseStation The Roger Earpiece output Clean the Roger Earpiece with is obstructed with wax...
  • Page 12: Performance

    8 Performance 9 Standards applied Frequency range Electrical safety: 2.402 GHz up to 2.480 GHz IEC/ EN 60950 Back-link power Radiocom 2.4 GHz: < 1 mW (0 dBm) EN 300 440 Audio bandwidth EMC: 100 Hz - 7200 Hz EN 301.489-1,-17 Output max SPL FCC: 100 dB SPL according to EU...
  • Page 13: Important Information

    Only supply your device using adapters supplied by Only use accessories that are approved by Phonak Phonak Communications. Communications AG. When the device is not in use, turn it OFF and store it...
  • Page 14: Other Important Information

    Declaration of conformity, please contact the order to check the device, as well as to help you use manufacturer or the local Phonak Communications AG your device correctly. representative whose address can be taken from the list •...
  • Page 15 FCC Caution: Any changes or modifications not device must accept any interference received, including expressly approved by the party responsible for interference that may cause undesired operation. The compliance could void the user’s authority to operate device has been tested and found to comply with the the device.
  • Page 16: Service And Warranty

    11.2 International warranty Local Phonak Communications AG representative: Phonak Communications AG offers a 2 (two) years limited international warranty, valid as of the date of purchase. This limited warranty covers manufacturing and material defects. The warranty is valid only if proof of purchase is shown.
  • Page 17: Explanation Of Symbols

    12 Information and explanation of symbols Important information for handling and product safety. The CE symbol is confirmation by Phonak Please read the information on the following Communications AG that this product is in pages before using your Phonak compliance with the essential requirements and Communications AG device.
  • Page 18 Manufacturer: Phonak Communications AG Laenggasse 17 CH-3280 Murten Switzerland www.phonak-communications.com...

Table of Contents