Testing Getting Started; Changing The Measurement Function - LaMotte Tracer PockeTester Manual

1.800.561.8187
TESTING
Getting Started
1. Remove the cap from the bottom of the TRACER to expose the electrode.
2. Before the fi rst use, rinse the electrode in deionized water and dry.
3. For best results, calibrate for conductivity with a standard in the expected
range of the sample. For maximum accuracy calibrate from low conductivity
value standards to high conductivity value standards.
4. Store dry.

Changing the Measurement Function

The meter can be set to measure Conductivity, TDS (ppm), TDS (mg/L) or
Salinity (ppm). To change the mode:
1. Turn the TRACER on.
2. Press and hold the MODE button for 2 seconds. The display will begin to
scroll through the units.
μS or mS (Conductivity)
ppm (TDS)
ppm (Salinity "S")
3. Release the MODE key when the desired mode is displayed.
4. Note that the "HOLD" function can not be on when changing functions.
www.
information@itm.com
.com
9