Preparing For Installation; Changing Color Panels - Whirlpool RUD0800EB Installation Instructions Manual

Preparing for Installation
1.
2.
3.
4.
5.
Remove the two bottom screws in the access
panel/toeplate (see Figure 3).
Open the dishwasher door and remove the two
top screws.
Close the door. The access panel can now be
removed by pulling it forward.
Remove four screws to remove the toeplate.
If required, install a 90" elbow (not included) into
the water valve. Use Teflon@ tape to seal the
elbow into the valve fitting. Valve fitting is 3/~"
National Pipe Thread.
Changing Color Panels
Select models are equipped with reversible door and
access panel inserts that offer three decorative
colors. To change exposed color panel, proceed as
follows.
It
is best to change color panels before
ins tailing dish washer.
NOTE: Handle panels carefully to avoid
injury or cuts.
1. Remove frame strip from one side of the door
panel. Loosen, but do not remove screws from
frame strip on remaining side (see Figure 4).
2. Remove frame strip from one side of the access
panel. Loosen, but do not remove screws from
frame strip on remaining side (see Figure 4).
3. Slide insert panels out of frame. Put color panel of
choice to outside and replace panel in frame.
4. Be sure edges of insert panels are under frame
strips on opposite side. Press strips tightly against
panels before securing screws. Replace frame
strips.
For best appearance, remove the protective film
covering the frame strips after installing your
dishwasher.
5