Start The Drying Cycle - BOMANN WT 5019 Instruction Manual

• The last section of the drying cycle is done without heat (cool down
cycle) to ensure that the items of washing remain at a temperature
which does not lead to the washing being damaged.
• Remove all objects from pockets, such as matches and lighters.
• Close zips, buttons, or hooks before drying. Tie loose straps or loops
together.
Putting the washing into the dryer
• Shake out the washed fabrics and sort them according to
the required drying setting, fibre, and fabric type, size, as
well as remaining moisture after spinning. This will make
the drying very consistent.
• Each load should correspond to the rated capacity of the
appliance.
• Ensure that no items of washing are trapped in the door.
Control panel
1 On/Off
This button is used to switch the power supply on and off.
2 PROGRAMM
Select one of four drying programmes by pressing the
programme selector several times. The corresponding
control lamps indicate the selected programme. Details
on the programmes can be found in the section "Drying
programme table".
Automatic drying programmes
The device detects the moisture in the load and auto-
matically adjusts the optimum drying time. The electronic
control ensures the best drying results even at less loading
of the dryer.
Drying programme table
NOTE:
• The figures listed below are approximate figures and recommendations under normal operating conditions and are therefore
for information only.
• The programme running times may deviate from the specified figures according to load, remaining moisture, and temperature.
18
3 TROCKNUNGSSTUFE
Select the drying settings by pressing the button several
times: EXTRA – STANDARD – LIGHT. The corresponding
control lamps indicate the selected drying setting.
4 Activation/ Deactivation of the child lock
A child lock is available in order to prevent interruption of
the operation of the appliance through misuse by play-
ing children. After starting the programme, hold down the
PROGRAMM and TROCKNUNGSSTUFE buttons for a
few seconds. A beep will sound. All buttons, apart from the
On/Off button, are locked. If the child lock is activated, any
invalid button press is indicated by a beep and the control
lamp lights up. Hold down both buttons again at the same
time to deactivate the child lock. A beep sounds again and
the control lamp goes out.
5 START/PAUSE
Press the button to start or pause operation. If the
programme is running, the programme control lamp of the
selected programme will flash. If the programme is paused,
the programme control lamp will be continuously lit. If no
programme is started within approx. 10 minutes, the appli-
ance switches off automatically.
6 KNITTERSCHUTZ
This function is designed to prevent creasing. After the end
of the programme, the appliance adds an automatic anti-
crease phase of approx. 30 minutes, if the fabrics are not
removed immediately after the end of the programme. If
the anti-crease function is activated, the dryer will continue
to turn the drum at intervals for approx. two hours. The
relevant control lamp indicates the activation of the anti-
crease function.

Start the Drying cycle