Table of Contents
Advertisement
Wireless
Enable or disable the AP 2.4GHz wireless radio. When
disabled, no 2.4GHz SSIDs will be active.
Band
Wireless standard used for the AP.
Combinations of 802.11b, 802.11g & 802.11n can be selected.
Enable SSID
Number
Select how many SSIDs to enable for the 2.4GHz frequency
from the drop down menu. (A maximum of 16 can be
enabled)
SSID#
Enter the SSID name for the specified SSID (up to 16). The
SSID can consist of any combination of up to 32 alphanumeric
characters.
VLAN ID
Specify a VLAN ID for each SSID.
Auto Channel Enable/disable auto channel selection.
Enable: Auto channel selection will automatically set the
wireless channel for the AP2.4GHz frequency based on
availability and potential interference.
Disable: Select a channel manually as shown in the next table.
Auto Channel
Select a range to which auto channel selection can choose
Range
from.
Auto Channel
Select a time interval for how often the auto channel setting
Interval
will check/reassign the wireless channel.
Check/uncheck the "Change channel even if clients are
connected" box according to your preference.
Channel
Select the channel bandwidth:
Bandwidth
- 20MHz (lower performance but less interference).
- 40MHz (higher performance but potentially higher
interference).
- Auto (automatically select based on interference level).
BSS
This is a series of rates to control communication frames for
BasicRateSet
wireless clients.
39
Advertisement
Table of Contents
