Lutron Electronics LTEA4U1UKL Series Installation Manual

LTE 2-Wire Forward-Phase
ULR Listed Driver | Installation
LTEA4U1UKL-AV120 (12 V)
LTEA4U1UKL-CV240 (24 V)
LTEA4U1UKL-XXXXX
R
120 V~ 50 / 60 Hz UL Listed Driver
Important Notes:
Please read before installing.
• For installation by a qualified electrician in accordance
with all local and national electrical codes.
• Use copper conductors only.
• For indoor use only.
• Check to see that the driver type and rating are suitable
for the application.
• DO NOT install if product has any visible damage.
• If moisture or condensation is evident, allow the product
to dry completely before installation.
• Operate between 32 °F (0 °C) and 104 °F (40 °C) ambient.
• 0% to 90% humidity, non-condensing.
Install the ULR Listed Driver
Shock Hazard. May result in serious
WARNING
injury or death. Turn off power at circuit
breaker before installing the unit.
When installing the ULR Listed Driver,
wire as shown.
1. Remove driver and mounting plate from the rest of the junction box.
Do not remove driver from mounting plate.
2. Using leads and ground (bundled in junction box) make power,
load, and ground connection with provided wire nuts (see wiring
diagrams).
3. Re-install LED driver and mounting plate to the junction box.
4. Ensure compatible dimmer and load are installed and restore
power to circuit. See reverse side for Compatible Controls.
6
Driver and junction box must be grounded in accordance with
local and national electrical codes. Ground provided by grounding
of junction box and by using the green ground wire connection.
Lutron Electronics Co., Inc. | 7200 Suter Road
Coopersburg PA, 18036-1299
English
Required Components
041549
Rev. A 1, 2
One Compatible LutronR Control
04/2016
1 See list of compatible controls on
reverse side.
2 Please refer to Installation Sheet with
your control for wiring instructions.
From
Neutral Dimmed Hot
Line / Control
120 V~ 50/60 Hz
To LED
Load
Ground / Bare
+ LED - LED
Need Help? www.lutron.com/hilume1led or call the Lutron
For each system ensure you have:
R
At least one ULR Listed Hi-lume 1% 2-Wire LED Driver
3 Driver output range is factory-set.
Different output ratings are available for different loads.
Controls Requiring a Neutral Wire
Hot
Neutral
Neutral
Dimmed Hot
(Black)
Neutral
OR
(White)
Ground
Controls Not Requiring a Neutral Wire
(Green)
- V
(Black with
white stripe)
+ V
(Red)
Hot
Neutral
LED Center of Excellence at 1.877.346.5338
®
At least one compatible LED Load (light engine)
3
4 Maximum and minimum loads are dependent on driver
output ratings. For voltage drivers, 5 W is the minimum
load requirement and 40 W is the maximum load
requirement.
5
Load ratings must match driver output ratings.
LutronR
Neutral
Dimmed Hot (Black)
Wire
Control
ULR Listed
Hi-lumeR
1% 2-Wire
LED Driver
Ground
Neutral (White)
Ground (Green) 6
Ground 6
LutronR
Non-
Dimmed Hot (Black)
Neutral
Wire
Control
ULR Listed
Hi-lumeR
1% 2-Wire
LED Driver
Ground
Neutral (White)
6
Ground (Green)
Ground 6
4, 5
+ V (Red) + LED
LED Light
Engine
- V - LED
(Black with White Stripe)
+ V (Red) + LED
LED Light
Engine
- V - LED
(Black with White Stripe)