Before Starting - Whirlpool DU4500XM Use & Care Manual

Cycle Selector Buttons
Option Selector Buttons
Before starting your dishwasher
1. Spin the Upper Spray Arm to make
3. Run hot water at sink nearest dish-
sure nothing will stop it from turning washer until it is hot. Turn it off.
freely.
2. Close and latch the door.
Starting your dishwasher
HEAVY WASH Cycle
1.
2.
3.
4.
Make sure Cycle Control Knob points
to dot marked HEAVY WASH.
Push HEAVY WASH button.
Push button for option desired.
Without turning it, pull out the Cycle
Control Knob to start the cycle.
ENERGY SAVING WASH Cycle...
1. Turn Cycle Control Knob until it stops at dot
marked ENERGY SAVING WASH.
2. Select option.
3. Withoutturning it, pull the Cycle Control Knob
out to start the Cycle.
RINSE & HOLD Cycle...
1. Push the RINSE HOLD Cycle Button.
2. Unlatch door and open slightly.
3. Pull Cycle Control Knob out.
4. Turn Control Knob clockwise to dot marked
RINSE & HOLD.
5. Close and latch the door to start the cycle.
Changing a setting
2. With the Cycle Control Knob pulled out,
You can change a setting any-time during
turn clockwise to the cycle you want.
any cycle.
3. Be sure the detergent dispensers are filled
1. Unlatch the door to stop the cycle, but don't
properly for the new cycle.
open it until the spray arms stop spinning.
4. Latch the door to start the cycle.