Download Print this page
Whirlpool DU851SWP Dimensions
Whirlpool DU851SWP Dimensions

Whirlpool DU851SWP Dimensions

Undercounter dishwasher

Advertisement

Quick Links

Undercounter Dishwasher
PRODUCT MODEL NUMBERS
DU400SWK
DU915PWS
DU810SWP
DU915PWW
DU811SWP
DU930PWP
DU840SWP
DU930PWS
DU850SWP
DU945PWP
DU851SWP
DU945PWS
DU895SWP
DU948PWP
DU915PWP
DUL140PP
Electrical: 120-volt, 60 Hz, AC-only, 15 or
20 amp. electrical supply. Use copper wire only. A
time-delay fuse or circuit breaker and separate
circuit is recommended.
Water: A hot water line with 20-120 psi
(138-862 kPa) water pressure. Water temperature
must be 120°F (49°C) at dishwasher. Use 3/8" O.D.
copper tubing with compression fitting (1/2"
minimum plastic tubing is optional but not
recommended). Use a 90° elbow with 3/8" N.P.T.
external pipe threads on one end to connect to
water inlet valve. Do not solder within 6" (15.2 cm)
from water inlet valve.
Drain: Use the new drain hose supplied with your
dishwasher. If this is not suitable, use a new drain
hose with a maximum length of 12 ft (3.7 m)
that meets all current AHAM/IAPMO test
standards, is resistant to heat and detergent, and
fits the drain connector of the dishwasher. Must
have a high drain loop 20" (50.8 cm) above the
subfloor or floor. Connect drain hose to waste tee or
disposer inlet above drain trap in house plumbing
and 20" (50.8 cm) minimum
above the floor. An air gap must be used if the
drain hose is connected to house plumbing lower
than 20" (50.8 cm) above subfloor or floor. Use 1/2"
minimum I.D. drain line fittings.
Corner location: Requires a 2" (5.1 cm)
minimum clearance between the side of the
dishwasher door and wall or cabinet.
A side panel kit is available from your dealer for
installing your dishwasher at end of cabinet.
Grommet is required for electrical cable or power
supply cord hole cut in a metal cabinet.
Do not install dishwasher over carpeted floor.
CUSTOM FRONT PANEL DIMENSIONS (Framed)
These panels fit only models with frames around the door and access panels.
7/32"
(5.6 mm)
door panel
3/8"
(side view)
(9.5 mm)
18 21/32"
1"
(47.4 cm)
(25.4 mm)
7/32"
(5.6 mm)
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
OVERALL DIMENSIONS
*
CABINET OPENING DIMENSIONS
(10.2 cm)
door panel (front view)
NOTE: Access panel is wider than door panel.
access panel
(front view)
All edges routed to 7/32" (5.6 mm) thickness.
22 31/32"
(58.3 cm)
24" (61 cm)
33-7/8"
(86 cm) min.
to front of
door frame
20-3/4"
(52.7 cm)
24" (61 cm)
*Measured from the lowest point on the
underside of countertop. May be reduced
to 33-7/8" (86 cm) by removing wheels
from dishwasher.
**Minimum, measured from narrowest point
of opening.
6"(15.2 cm)
4" (10.2 cm)
4"
10"
2-1/2"
(25.4 cm)
(6.4 cm)
5" (12.7 cm)
2"
(5.1 cm)
Water line entering through the
left side of opening in shaded
areas makes connection easier.
Minimum 1/2" (12,7 mm) hole.
23 5/16" (59.2 cm)
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
*
23-7/8" (60.6 cm)
**
24" (61 cm)
6"(15.2 cm)
4"
(10.2 cm)
2-1/2"
(6.4 cm)
2"
5" (12.7 cm)
(5.1 cm)
Drain hose and power supply line entering through the right
side of opening in shaded areas makes connection easier.
Drain hose size: 1-1/2" (3.8 cm)
Power supply line hole-direct wired: 3/4" (1.9 cm)
Power supply line hole-with plug: 1-1/2" (3.8 cm)
Cut door panel to clear access panel when
door is in open position
side view
door opened
7/32" (5.6 mm) thick
top view
access panel frame
*
34" (86.4 cm) min.
.
door closed
door pivot
access panel
1/4"
(6.4 mm) min.
Ref. 8535436
09-17-09

Advertisement

loading

This manual is also suitable for:

Du915pwpDu915pwsDu915pwwDu930pwpDu930pwsDu945pwp ... Show all