Whirlpool 400 Series Use And Care Manual page 11

Using the rinse agent dispenser
Keep the rinse agent dispenser filled with a
liquid
rinse
agent.
A rinse agent greatly
Improves dish drying by helping water
fIow off them during the last rinse.
A rinse
agent also keeps
water from forming
droplets
and
drying as spots or streaks.
A small amount of rinse agent automati-
cally releases into the rinse water during the
final
rinse of
each cycle.
For best drying
results, check dispenser periodically to
see if It needs filling.
To check dispenser:
l
Check center of Fill Indicator Cap. Clear
means it needs filling.
OR
l
Remove Fill Indicator Cap. An "F is visible
when dispenser is empty.
To fill dispenser:
The rinse agent
dispenser holds 6 ounces
(175 mL). Under normal conditions, this
lasts about 3 months.
1. Open dishwasher door completely.
2. Remove Fill Indicator Cap.
3. Add rinse agent. Fill to smallest opening
in lower part of dispenser only. Overfilling
may cause rinse agent to leak out. This
will not harm the dishwasher, but could
cause oversudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. Replace Fill lndiitor Cap. Keep it closed
tightly.
NOTE: You do not have to wait until the
diinser is empty before refilling, but do
not
overfill
it.
Your
dishwasher
is designed
to use a liquid rinse agent. You do not need
to use a solid or bar-type rinse agent.
Cap center clear
"E" visible
when empty when empty
Do not fill paat
l mbdleat opening
Keep
dispenser filled for best drying resutts
11