Unit Installation; Inspection Before Installation; Unloading And Hoisting Requirements - Trane CXAJ065 Installation, Operation And Maintenance Manual

Unit Installation

Inspection before Installation

1. Whether the nameplate of the unit is consistent with
the model in the order;
2. Whether all the accompanying documents for the
unit are available;
3. Whether the accessories of the unit are consistent
with the items listed in the packing list;
4. Upon receipt of the unit, please carefully inspect
whether the unit is damaged in transit. If any, please
record it on the delivery note, notify the final carrier
in writing within 72 hours and notify the local Trane
sales office at the same time.
Unit Hoisting Diagram
Hoisting Diagram
and Instructions
Inspection before hoisting
1. Inspect whether the unit periphery and the
fixed parts are intact.
2. Inspect whether the unit and the packaging
baseplate are intact.
Suggestion: remove the packaging baseplate to
hoist for fear of drop.
Hoisting
1. Hoisting operation shall be performed by the personnel
with hoisting qualification.
2. Thread the sling into 4 lifting eyes at the top of the unit.
3. The sling shall have enough capacity of bearing the unit weight.
4. The sling tying length shall be suitable, and the sling lifting angle
shall be more than 45 degrees.
Ensue safety.
Handle with care.
 D
Warning
During hoisting, ensure stable hoisting of the outdoor unit, and avoid uneven weight distribution of the unit. If the
center of gravity is on the side of the compressor, trial operation should be performed before hoisting. Observe
whether the sling is tied tightly and whether the unit is at the risk of toppling. When hoisting, rise slowly and evenly
to prevent the unit from tipping over and ensure the safety of people around!
10
Unloading and Hoisting
Requirements
Please handle the unit to its installation position by
using a forklift, crane or hoist with appropriate tonnage.
During handling, keep the machine horizontal, and
avoid damage to the unit due to reckless operation.
Lifting angle
Unit
Packaging baseplate
Sling
PKGP-SVX18B-EN