ZyXEL Communications NBG6604 User Manual page 11

Table 1 Top Panel LEDs (continued)
FUNC T IO N C O L O R
WLAN 2.4G White Amber
Note: When you connect the power, only the power/sys LED blinks. Others are off -> system ready ->
all LEDs follow their behavior described in this table.
Table 2 Buttons and Interface Behavior
FUNC T IO N L ABEL
Power Jack DV IN
12v 1A
Reset/Restore Button Reset
WPS Button
Ethernet LAN LAN
WAN
Rear Panel
Fig ure 2
WAN Po rt
Chapter 1 Introduction
ST AT US BEHAVIO R
On The WLAN interface is enabled.
Off The WLAN interface is disabled.
White blinking The NBG6604 is transmitting/receiving data.
Amber blinking The WPS process is in progress (at the same time, disable the
white LED).
Amber steady off The WPS process is inactive.
DESC RIPT IO N/ BEHAVIO R
Connect the included power adapter.
- Press the button for 5 or less than 5 seconds, system will
reboot.
- Press the button for more than 5 seconds, system will reset
configuration.
- WPS button can trigger both 2.4G and 5G.
- WPS can work with 2.4G and 5G at the same time.
- WPS LED will be off while the device is connected to clients
(2.4G client or 5G client or both 2.4G/5G clients).
WAN x1:
- RJ45 Connector
LAN x4:
- RJ45 Connector
WAN
LAN
L AN Po rts 1- 4
NBG6604 User's Guide
11
Re se t Butto n
DC I N
Po we r Input
L O C AT IO N
Rear
Rear
Top
Rear