Triax COFDM User Manual page 17

Rev. 05 - 2011 - B
Enter a new IP address, subnet mask and default gateway in the correspond-
ing fields.
In case you need to reset the IP address to the factory default address, you
have to use the ID switch.
To return to factory default settings do the following:
• Switch off the power to the main unit.
• Set the ID switch on the main unit to "7", then switch on the power.
The four LEDs flash red and yellow until the process of resetting the IP
address has been completed.
If the reset process has been successful the LEDs will turn green.
If the reset process fails the LEDs will turn red.
• Switch off the power to the main unit.
• Set the ID switch on the main unit back to the initial setting.
• Switch on the power to the main unit.
Now you have reset the IP address to the factory default address.
Important
To make a changed IP address take effect you have to reboot
the TDX headend system using the Reboot button in the Sys-
tem maintenance area or switch off the power.
To output services using an IPTV system or to include a subunit in a network
you have to enter an IP address, subnet mask and default gateway for each
unit link socket you use.
With regard to IPTV you also have to enter a multicast IP address and a mul-
ticast port for each unit link socket you use. .
To enter the IP settings area, click the arrow bracket to the left of IP settings.
Now click the Unit link 1 tab to display the relevant fields.
TDX Service Tool
17