Lights Other Than The Above; When Installing The Rubber Cover Of The Headlight; Led Lights; Condensation Build-Up On The Inside Of The Lens - Toyota Avanza Owner's Manual

Lights other than the above

■
If any of the lights listed below has burnt out, have it replaced by
your Toyota dealer.
● Headlights (vehicles with LED type)
● High mounted stoplight (if equipped)
● License plate lights
● Side turn signal lights on the outside rear view mirror (if
equipped)
● Rear fog light (if equipped)
When installing the rubber cover of the headlight (halogen bulb type
■
only)
Ensure the rubber cover is securely attached.
Fit the rubber cover outer circumfer-
1
ence in firmly.
Fit the rubber cover around the light
2
bulb until the light bulb plug can be
seen.

LED Lights

■
The following lights consist of a number of LEDs. If any of the LEDs burn out,
take your vehicle to your Toyota dealer for replacement.
Headlights (vehicles with LED type)
●
Side turn signal lights on the outside rear view mirror (if equipped)
●
Rear fog light (if equipped)
●
High mounted stoplight (if equipped)
●

Condensation build-up on the inside of the lens

■
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction. Contact your Toyota dealer for more information in the
following situations:
Large drops of water have built up on the inside of the lens.
●
Water has built up inside the headlight.
●
When replacing light bulbs
■
→P. 278
AVANZA_OM_General_OMBZ214
7-3. Do-it-yourself maintenance
291
7