114
3-5. Opening and closing the windows
Operating the power windows after turning the engine off
■
The power windows can be operated for approximately 40 seconds even
after the engine switch is turned to the "ACC" or "LOCK" position.
Jam protection function (driver's window only)
■
If an object becomes caught between the window and the window frame, win-
dow travel is stopped and the window is opened slightly.
When the power window does not close normally
■
If the jam protection function is operating abnormally and a window cannot be
closed, perform the following operations using the power window switch on
the driver's door.
After stopping the vehicle, hold the power window switch in the one-touch
closing position while the engine switch is turned to the "ON" position.
Continue holding the switch for a further 6 seconds after the window has
closed.
If you release the switch while the window is moving, start again from the
beginning.
If the window re-opens slightly even after performing the above procedure
correctly, have the vehicle inspected by your Toyota dealer.
If the battery is disconnected
■
The power windows must be initialized in order to ensure proper operation.
Hold the power window switch in the one-touch opening position until the
1
window has opened completely while the engine switch is turned to the
"ON" position.
Hold the power window switch in the one-touch closing position. Continue
2
holding the switch for a further 2 seconds after the window has closed
completely.
AVANZA_OM_General_OMBZ214