Use electrically insulated tools to reduce the documents published on our website at: http://www. risk of electric shock. canadiansolar.com as such lists are updated on a regular basis. Prior to installation, remove all metallic jewelry to prevent accidental exposure to live circuits.
Inc. crystalline silicon PV modules can be found in Annex C from the modules or an external source is present. (Module Specifications) on www.canadiansolar.com. Main electrical characteristics at STC are also stated on each · Do not allow children or unauthorized persons near the module label.
Table 1: Low temperature correction factors for open-circuit voltage Lowest Expected Ambient Temperature (°C/°F) Correction Factor 24 to 20 / 76 to 68 1.02 19 to 15 / 67 to 59 1.04 14 to 10 / 58 to 50 1.06 9 to 5 / 49 to 41 1.08 4 to 0 / 40 to 32...
· Do not drop or place objects (such as tools) on the · Consult your local authority for guidelines and modules. requirements for building or structural fire safety · Do not use sharp instruments on the modules. Particular UL 1703 SYSTEM FIRE RATING REQUIREMENTS care should be taken to avoid module glass being damaged by sharp objects, as scratches may directly affect product safety.
sulfur (i.e. sulfur sources, volcanoes) incurs the risk of modules is required to allow for thermal expansion of module corrosion. the frames. · Failure to comply with these instructions will void · The small drainage holes on the underside of the module Canadian Solar Inc.
Annex B ensure that the conductor ampacity complies with local (Alternative Grounding Methods) on the website (www. regulations (i.e. NEC 690.8(D)). canadiansolar.com). CABLE AND CONNECTOR PROTECTION GROUNDING METHOD: BOLT + TOOTHED NUT + CUP WASHER ·...
Canadian Solar Inc. for special module ran- 6.0 MOUNTING INSTRUCTIONS ges, please refer to the Annex A (Alternative Mounting Methods) on our website (www.canadiansolar.com). For · The mounting design must be certified by a registered information about other installation methods, please professional engineer.
Page 11
| 1 InstallatIon manual annex of alumInum fRame DYmonD moDule for professional use only...
Page 12
In the event of any inconsistency among different language versions of this document, the English version shall prevail. Please refer to our product lists and documents published on our website at: http://www.canadiansolar.com as these lists are updated on a regular basis.
Page 13
| 3 annex a: alteRnatIve mountIng methoDs All the basic requirements of the main aluminum (0.2 in) frame Dymond installation manual should also apply to Ensure to overlap in length by at least 80 mm (3.15 alternative mounting methods, unless otherwise specified. in).
Page 14
4 | table a Cs6K-p-ag, Cs6K-ms-ag, Cs3K-p-ag and Cs3K-ms-ag Use four clamps on the long side. Mounting rails Use four clamps on the short side. Mounting rails run perpendicularly to the long side frame. run parallel to the long side frame. A1 range = (240 –...
Page 15
| 5 m o u n t I n g m e t h o D B : C e n t e R C l a m p mountIng methoD (sIngle-axIs tRaCKeR) · Canadian Solar Inc. modules can be mounted on single- axis trackers using center clamps or mounting holes as described below.
Page 17
| 7 max. open short maximum operating operating series overall Circuit Circuit Weight model type power voltage current fuse Dimension voltage Current <Kg> pmax<W> vmp <v> Imp <a> Rating <mm> voc <v> Isc <a> <a> Cs3u-390ms-ag 40.4 9.66 48.2 10.17 Cs3u-395ms-ag 40.6 9.73...
Page 18
8 | annex D: moDule CleanIng guIDelInes This manual covers the requirements for the cleaning · Do not use de-greasers on the module. procedure of Canadian Solar Inc. photovoltaic modules. The purpose of these cleaning guidelines is to provide · Do not use cleaning corrosive solutions containing acid, alkali, acetone, or industrial alcohol.
Page 19
| 9 amenDeD eDItIons anD Dates · Rev A0 is released in October, 2017. · Rev A1 is released in February, 2018. CanaDIan solaR InC. 545 Speedvale Avenue West, Guelph, Ontario, Canada N1K 1E6 www.canadiansolar.com...
Need help?
Do you have a question about the CS6K-245P-AG and is the answer not in the manual?
Questions and answers