Ceramic Surface Units; Installing - Whirlpool RC8700ED Use And Care Manual

Ceramic Surface Units

Installing

You can install ceramic surface units in the
left basin (Model RC8720ED) or both basins
(Model RC8700ED) of your cooktop.
NOTE: The pictures in this section show the
ceramic surface unit installed in the left
basin, where the receptacle is in the front
wall of the basin. To get the ceramic
surface unit accessory, order Part Number
RCM30DB/DQ from a Whirlpool service
company or dealer (see Step 2 on page 38)
or call the Whirlpool Consumer Assistance
Center toll-free 1-800-253-1301.
To install:
1. Make sure the control knobs are
turned off.
2. If the grill grates, element, and grill-rocks
are in place, remove them before install-
ing ceramic surface units. Clean out any
grease that may be in the basin. (See
page 24 for more information.)
Terminal
receptacle
Terminal
plug
3. Position the accessory terminal plug
towards the terminal receptacle.
16
Terminal
receptacle
Terminal
plug
4. Slide the accessory towards the recep-
tacle until the terminal plug is firmly set in
receptacle.
5. Lower the opposite end of the accessory
into the cooktop until it is flush with the
surface.