Latch Mode - Electro-Harmonix Pitch Fork+ Manual

LATCH MODE – Latch mode selects how the BYPASS footswitch operates.
It can be set to either latching or momentary with glissando (glide) effect
control.
LATC
– Latching mode toggles the effect ON/OFF with each press
▪
of the BYPASS footswitch.
MOME.
▪
the BYPASS footswitch is pressed. The speed of glissando's rise
and fall times and the SHIFT channels affected are set in the
following sub-menus. Press VALUE to enter momentary mode's
main menu:
•
•
•
•
– Momentary mode engages the glissando effect when
RISE.
– Press, then turn VALUE to adjust how quickly the
glissando rate goes from unison to the SHIFT setting
when the BYPASS footswitch is pressed and held. When
set to 0, the rise-time is 4ms. At the maximum setting of
100, the rise-time is 4 seconds.
FALL.
– Press VALUE then turn to adjust how quickly the
glissando rate goes from the SHIFT settings back down to
unison upon release of BYPASS. The minimum rate is 4ms
and maximum is 4 seconds. The BYPASS LED will remain
lit until the glissando fall rate returns back to
unison/BYPASSED.
LINK.
– Press VALUE and turn to toggle LINK ON/OFF.
When set to ON the RISE setting is used for both RISE
and FALL.
DEST.
– Press VALUE to enter the glissando destination
sub-menu. Destination is the SHIFT channel that is
affected by the glissando effect control:
SHF1
-
SHF2
-
BOTH
-
– SHIFT 1 only
– SHIFT 2 only
– SHIFT 1 & 2 have glissando control
13