Cleaning; Optional Equipment; Storage - RIDGID RBC-121 Manual

RBC-121 Battery Charger
3. When charger is in standby "ready to
charge" mode, the yellow LED light will
blink continuously.
4. With dry hands, insert the battery pack
onto the charger. Do not force the battery
into the charger. The battery pack will
begin charging automatically. The bat-
tery pack will become slightly warm to
the touch during charging. This is normal
and does not indicate a problem. The
LED light on the battery charger will indi-
cate charging condition (Figure 5 and
Figure 6 Chart).
Once the battery is charged, it may remain
on the charger until use.
5. When charging is complete, with dry
hands, remove the battery from the
charger and unplug the charger from
outlet.
Inserting/Removing Battery
1. With dry hands, insert battery into tool re-
ceptacle. Battery only fits into tools one
way. If the battery will not fully seat into
the receptacle, do not force. As the bat-
tery is inserted, the tabs will engage the
tool to retain the battery in place.
2. To remove battery, depress tabs and pull
straight out (Figure 2).
3 Always remove the battery from the tool
when making adjustments, changing at-
tachments or storing.

Cleaning

WARNING
unplug charger and remove the battery
before cleaning. do not use any water or
chemicals to clean charger or battery to
reduce the risk of electrical shock.
Remove any dirt or grease from the exterior of
the charger and battery pack with a cloth or
soft, non-metallic brush.

optional equipment

WARNING
To reduce the risk of injury, only use op-
tional equipment specifically designed
and recommended for use with the
6
RIdGId RBC-121 Battery Charger, such
as those listed below.
Catalog
No.
55193 Charger
55198 Charger
55203 Charger
55208 Charger
55213 Charger
55218 Charger
44798 Charger Cord
44808 Charger Cord
44803 Charger Cord
44813 Charger Cord
44818 Charger Cord
44828 Charger Cord
Batteries
Catalog
No. Model
55183 RB-1225
All listed batteries will work with any catalog number RBC-121
Battery Charger.
For a complete listing of RIdGId
equipment available for this tool, see the
Ridge Tool Catalog online at RIdGId.com
and RIdGId.eu or call Ridge Tool Technical
Service department (800) 519-3456.

Storage

Store the charger and batteries
WARNING
in a dry, secured, locked area that is out of
reach of children and people unfamiliar with
proper charger operation.
Remove batteries from tool or charger before
storage. The battery packs and charger should
be protected against hard impacts, moisture
and humidity, dust and dirt, extreme high and
low temperatures, and chemical solutions and
vapors.
Long term storage in the fully
NOTI E
charged state, the fully discharged state or in
temperatures above 140°F (60°C) can perma-
nently reduce the capacity of a battery pack.
Region
USA, Canada and Mexico
Europe
China
Australia & Latin America
Japan
United Kingdom
North America
Europe
China
Australia & LA
Japan
United Kingdom
Capacity
12V 2.5Ah
® optional
Plug
Type
A
C
A
I
A
G
A
C
A
I
A
G