Display Backlight; Display Contrast; Learning Mode; Tones - Whirlpool GH7208XR Use & Care Manual

Display Backlight

Display backlight may be set to reduce brightness or to turn off
during sleep mode.
Sleep mode is an energy-saving feature that darkens the display
backlight after 2 minutes of inactivity. During sleep mode, only
the time and date are visible, along with instruction to touch the
screen to reactivate the Main Menu.
To Set Display Backlight:
1. On Main Menu, touch "Settings & Info."
2. Touch "Display Backlight."
3. Select setting: reduce after 2 minutes or off after 2 minutes.
4. Touch "OK."

Display Contrast

Display contrast has 11 settings, ranging from minimum to
maximum.
To Set Display Contrast:
1. On Main Menu, touch "Settings & Info."
2. Touch "Display Contrast."
3. Using "+" and "-" controls, increase or decrease the contrast.
4. Touch "OK."

Learning Mode

The Learning Mode is ideal for learning how to use the oven.
When set, functions can be entered, with real displays and tones,
without actually turning on the microwave generator (magnetron),
grill element or convection element. While functions are operating
in the Learning Mode, the oven light will come on, the fan will run,
and the turntable will rotate (if set ON).
While the Learning Mode is active, the Learn indicator is visible in
the lower, left command area. The indicator is visible while the
oven is in stand-by mode, during programming, and during
Settings & Info menu navigation.
The Learning indicator shares the lower, left command area with
the Timer countdown if both are in operation.
Cook Method
Food Type
A
A. Learning mode indicator
To Activate Learning Mode:
The oven must be off.
1. On the Main Menu, touch "Settings & Info."
2. On Settings & Info screen, touch "More Choices."
3. Touch "Learning Mode."
4. Touch "On" or "Off" to set.
5. Touch "OK."
Time / Temp /
Most Used
Power
Kids Menu Settings & Info
Tones are audible signals, indicating the following:
One Tone
Valid entry (short tone)
Two Tones
Between stages (short tones)
Reminder (long tones), repeat each minute for 10 minutes
after the end-of-cycle tones
End of Timer countdown
Hidden feature entered or exited (very short, quick tones)
Three Tones
Invalid entry (very short, quick tones)
Retry Error
Four Tones
End of cycle (2 short tones, followed by 2 longer tones)
Interruption, tend to food (short tones)
Attention - door needs to be opened and closed
To Adjust Tone Volume:
1. On Main Menu, touch "Settings & Info."
2. On Settings & Info screen, touch "More Choices."
3. Touch "Volume."
4. Using "+" and "-" controls, increase or decrease the volume
setting, or turn the tones off.
5. Touch "OK."
The START control will start any function.
If non-sensor cooking is interrupted, touching the START control
pad will resume the preset cycle.
For added convenience, the "Start" touch pad is also available on
some display screens, and provides the same function as the
START control pad.
The CANCEL control stops all functions except for the Timer and
Learning Mode, and cancels programming in progress.
The oven will also turn off when the door is opened. Close the
door and touch START control or "Continue" on the touch screen
to resume the cycle. A sensor cooking cycle may not be resumed
if interrupted by opening the door.
During programming the CLEAR control changes the numeric
programming values, such as minutes, seconds and cook power
that are active in the display to their default value. For example,
while entering a cook time, touching CLEAR will change the time
you have already entered to "0:00." The CLEAR control gives an
invalid signal (see "Tones" section) if touched during cooking.

Tones

Start

Cancel

Clear

13