General Information; Safety Advice; Start-Up Procedure - Cake OSA Series Manual

2. General information

2.1 Safety Advice

When riding a CAKE bike for the first time, there are a few things to consider.
The bike has an electric motor with instant torque and a primary drive with no
gears or clutch, which means you have all the power available at all times using
the throttle. It's very sensitive and it's highly recommended to start riding using
Ride Mode 1 in order to get used to riding the ÖSA.
• Learn the handlebar controls and how to operate the bike.
• Check the bike for any damages to make sure it's in a roadworthy condition.
• Never ride the bike under the influence of alcohol or drugs.
• Always check your local laws and regulations.
• Make sure that you have the correct driving license to operate the motorcycle on
the street.
• Always use the bike with appropriate gear and protection.

2.2 Start-up procedure

Your bike should be fully assembled. Check the chapter "5.3 Charging" to charge
the battery to full.
To start your ÖSA, follow the steps below
1. Battery. Start the battery by pressing the ON/OFF button on the right side of
the battery. The button should be pushed in and you will see white LED
lights indicating the battery's SOC (state of charge). Charge the battery if
empty or low. The battery is now powered on.
2. Kill switch. On the right side of the handlebar, you will find the kill switch,
flip the switch to activate.
3. Display. Press and hold the power button (white outline) on the display for 1
second. This will start the display and will let you enter your PIN code. The
bike comes with factory settings and the generic PIN code "123". Each
button has a corresponding digit, with the number being displayed on the
side of the button.