Worx WG547E Manual page 10

COMPONENT LIST
1. HANDLE
2. ON/OFF SWITCH
3. TUBE RELEASE BUTTON
4. UPPER BLOWER TUBE
5. LOWER BLOWER TUBE
6. MOTOR HOUSING
7. WALL HANGING SUPPORT
8. BATTERY PACK *
9. BATTERY PACK RELEASE BUTTON *
* Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type WG547E WG547E.1 WG547E.9
(520-559 - designation of machinery,
representative of Cordless Blower)
10
20V
Voltage
Air volume
Blower
Blower speed
Charger voltage 220-240V~50/60Hz
Charging time
Machine weight
* Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
NOISE DATA
A weighted sound pressure
A weighted sound power
Wear ear protection
Cordless Li-Ion Blower/Sweeper
WG547E
WG547E.9
WG547E.1
Cordless
20V Max*
I: 7.6m /min II: 10m /min
3 3
EN
I: 88km/h II: 120km/h
1 hr (approx.)
2.0kg 1.6kg
L = 75dB(A)
pA
K
pA
L = 87dB(A)
wA
K
wA
VIBRATION INFORMATION
Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
/
If the tool is to be used regularly then invest in anti
vibration accessories.
/
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Battery pack
(WA3551)
Charger
= 3dB(A)
(WA3880)
We recommend that you purchase your accessories
listed in the above list from the same store that sold
= 3dB(A)
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
WG547E WG547E.1 WG547E.9
1 2
1 1
a < 2.5m/s
2
h
K = 1.5m/s²
/
/
EN