Furuno FCV-1200L Service Manual page 30

JP1
JP2
JP4
JP3
Dip-switch
Note) L: input/output signal to/from terminal CN7.
S1 Factory Name
Setting
#1 ON KPOUT L POS
#2 OFF KPOUT L NEG
#3 ON KP IN L POS
#4 OFF KP IN L NEG
#5 ON LINEAR IN L
#6 OFF LOG IN L
#7 OFF KP IN L
#8 OFF WL IN L
Dip-switch
Note. L: H: input/output signal to/from terminal CN8
S2 Factory Name
Setting
#1 ON KPOUT H POS
#2 OFF KPOUT H NEG
#3 ON KP IN H POS
#4 OFF KP IN H NEG
#5 ON LINEAR IN H
#6 OFF LOG IN H
#7 OFF KP IN H
#8 OFF WL IN H
S1
S2
Figure 4.11 Rear View of EXIF 2 board (02P6279)
Select polarity of "KPOUT L" signal.
#1:ON, #2:OFF: positive
Set ON/OFF according to polarity of KP IN L inputted
#2:ON and #3:OFF for Positive KP input
#2:OFF and #3:ON for negative KP input
Set switches according to input signal ( SIG IN AC/DC ).
#5: ON and #6: OFF for the signal amplified by linear-amplifier.
#5 :OFF and #6: OFF for the signal amplified by log-amplifier.
OFF: KP IN voltage is 12 V
OFF: WL IN voltage is 12 V
Select polarity of "KPOUT H" signal
#1:ON, #2:OFF: positive , #1:OFF, #2:ON: negative.
Set ON/OFF according to polarity of KP IN L inputted.
#2:ON and #3:OFF for Positive KP input,
#2:OFF and #3:ON for negative KP input.
Set switches according to signal ( SIG IN AC/DC ) inputted.
#5: ON and #6: OFF for the signal amplified by linear-amplifier.
#5: OFF and #6: ON for the signal amplified by log-amplifier.
OFF: KP IN voltage is 12 V
OFF: WL IN voltage is 12 V
S3
Remarks
#1:OFF, #2:ON: negative
ON: KP IN voltage is 5 V.
ON: WL IN voltage is 5 V.
Remarks
ON: KP IN voltage is 5 V
ON: WL IN voltage is 5 V
27