Genie CT10 User Manual page 8

※ When measuring coaxial cable, if the cable is not connected or the cable length is below
10m, the measured value is displayed as Cable open or Too short.
※ When measuring UTP cable, if the cable is not connected or the cable length is below 5m, the measured
value is displayed as Cable open or Too short.
※ If the RJ45 connector of UTP cable is not connected properly or the cable length is too short, the
measurement error rate may increase or decrease. (Especially for cables below 10m, the error rate may
increase or decrease.)
5-4. Calibration
: Calibrate the cable that the user want to measure to the length and create
Load Data as standard.
• START: When set in menu, Green LED lights up on the Run button. Press the Run button to
measure the cable status.
It is able to measure the cable status several times by pressing Run button with Green LED on.
If the measured cable has an error compared to the standard value, use U, D(▲▼) Key to
change the calibrated value, press Enter Key to enter LOAD DATA NAME setup menu, and U,
D(▲▼) Key to set the cable name.
When the setting is completed, press Run Key to display stored location (LOAD2~LOAD8) and
NOT SAVE setting, and use U, D(▲▼) Key to set the storage location.
- 8 -