Genie CT10 User Manual page 15

10-2. How to measure Loop Resistance of coaxial cable
(Loop Resistance& BNC to TB (2P) Connector)
• Use to measure Loop resistance of coaxial cable.
• Connect the coaxial cable to the Cable Tester (BNC). Before measuring, connect BNC to TB
Connector with Straight Adaptor Jack-Jack connected to the end of the coaxial cable. The switch
of the connector should be set as LOOP.
※ If the product is connected to the cable, the loop resistance is not measured and displayed as
OPEN.
10-3. How to measure cable length by using BNC to TB Connector's switch set as CABLE
• Connect BNC to TB Connector to the BNC of the Cable Tester and connect the cable at the
terminal block of the connector. Set the switch of the connector as CABLE.
(It is able to measure cables without BNC connector or UTP RJ45 connector.)
- 15 -