Battery Status Indicator; Specifications - Genie CT10 User Manual

6. Battery Status Indicator

Status
Charging
Charging complete
Charger not connected
• USB 2.0 MINI-B Type (factory supplied) is recommended to use.
• Make sure to use over DC5V 1.5A for USB adapter charger.
• The remaining battery level is displayed, so it is able to manage the battery efficiently by
controlling the charging time.
• While the product is charging, the remaining battery level is not displayed.
• If the battery is running low, the product is automatically turned OFF. Connect the USB
charger and use the product.

7. Specifications

MODEL
Display
Cable Type
Coaxial Cable Length
Coaxial Cable LOOP Resistance
UTP Cable Length
Minimum Calibration Length
Accuracy (BNC, RJ45)
Connector Type
Battery Type
Temperature / Humidity
Charging Port
Full Charge Hour / Hours of Use
Dimensions (WxHxD)
Material / Weight
• Continuous use hour may vary depending on the measurement mode and cable length.
• The measured value may be displayed differently depending on the Load Data value and the cable
type.
• The maximum measured length of cable may vary depending on the cable manufacturer.
• If the connected cable is not the same specification with calibrated cable, measurement error may
occur.
• If the USB cable is disconnected while the battery is charging, the stabilization process may take one
or several minutes. (The shorter charging time is, the longer stabilization time is.)
Battery Indicator
BNC Coaxial /RJ45 UTP(T568A, 568B)
10m ~ 1.8km(MAX)
5m ~ 200m(STP 150m)
Over 100m Recommended (Calibration)
5%(After Calibration)
3.7V Rechargeable lithium battery 900mAh
-10℃ ~ +50℃ / 0 ~ 80%
USB 2.0 MINI-B Type, Over DC 5V 1.5A
2H 30M / RJ45(3H), BNC(6H)
74(W) X 33(H) X 120(D)mm / ±0.5mm
ABS UL94V-0/ 210g
- 12 -
LED Indicator
Red LED
Green LED
LED OFF
Cable Tester
1.5 inch OLED
Below 300Ω
BNC,RJ45
(USB charging adapter)