Salicru DC POWER-L Series User Manual page 33

•
BATT. QUICK CHARGING: The batteries are in quick
charging mode.
•
EXCEPTIONAL CHARGING: The batteries are in excep-
tional charging mode.
Screen 0.2
This screen shows the device's serial number.
Screen 0.3
This screen shows the device's software version.
9.3.2. 'Measurements' menu.
To access this menu from the home screen, press the forward
key () once. Use key () to access the screens of the different
sub-menus and move freely from one to the other by means of
keys () and ().
Screen 1.1
Main screen of the measurements menu.
Screen 1.2
This shows the device's output voltage and current.
Screen 1.3
This shows the voltage and current of the batteries.
Screen 1.4
This screen shows the charge level of the batteries in Ah.
Screen 1.5, 1.6 and 1.7
These screens show the RMS values of the input voltage between
the R-S, S-T and T-R phases respectively. For single-phase de-
vices, only screen 1.8, which shows the voltage between phase
and R-N neutral, is available.
Screen 1.8
This screen indicates the input voltage for single-phase devices.
Screen 1.9, 1.10 and 1.11
These screens indicate the input currents of the three phases.
Screen 1.12
This screen indicates the input current for single-phase devices.
Screen 1.13
This indicates the frequency value of the device's input voltage.
Screen 1.14
This displays the heat sink (HS) and battery (BATT) tempera-
tures in °C.
9.3.3. 'Maneuvres' menu.
To access this menu from the home screen, press the forward
key () twice. Use key () to access the screens of the different
sub-menus and move freely from one to the other by means of
keys () and ().
Screen 2.1
SALICRU
This is the gateway to the device's operations menu.
Screen 2.2
Manual and forced activation of quick charging.
Screen 2.3
Manual and forced activation of exceptional charging.
9.3.4. 'User Parameters' menu.
To access this menu from the home screen, press the forward
key () three times. Use key () to access the screens of the
different sub-menus and move freely from one to the other by
means of keys () and ().
Screen 3.1
This is the gateway to the User Parameters menu.
Screen 3.2
Selection of the language of the display messages from among:
Spanish, Catalan and English.
Screen 3.3
This shows the address and speed of the MODBUS protocol.
9.3.5. 'Alarms' menu.
To access this menu from the home screen, press the forward
key () four times. Use key () to access the screens of the
different sub-menus and move freely from one to the other by
means of keys () and ().
All of the alarm activation and deactivation conditions are estab-
lished in Table 7. Consult it to view the thresholds, limits or condi-
tions for each of them.
Screen 4.1
This is the gateway to the device's Alarms menu.
Screen 4.2
This alarm is displayed when the leakage current of the batteries
of the positive pole exceeds a certain value.
Screen 4.3
The alarm is activated when the electrolyte level of the battery in
which the sensor is installed is below the pre-defined ideal.
It is necessary to consider that the level test is performed on a
single battery and the result is accepted as generic for the others.
Although unlikely but not impossible, the exceptional case may
occur that the level is low in one or more batteries and is correct
in the one where the sensor is installed.
Screen 4.4
The alarm warning appears when the device's output voltage ex-
ceeds a certain value.
Screen 4.5
This alarm appears when the device's output voltage is below a
certain value.
33