Screen Messages - GE DigitalFlow GS868 Service Manual

Chapter 2. Error Codes and Screen Messages

2.18 Screen Messages

A variety of messages may appear on the display screen during the performance of a task. Since the error codes have
already been discussed in this chapter and the locator bar messages are discussed in detail in Chapter 3, Operation, of
the Startup Guide, they will not be repeated here. All other messages are listed in Table 2-1 below.
Message
Backup Battery FAIL The backup battery that powers the non-volatile RAM has failed.
Backup Battery OK
DSP Processor OK
DSP RAM Failed
DSP RAM OK
EPROM sum =
XXXX
FRIGID_INIT
Executed
NVR FAIL
NVR OK
All Logs Cleared!
hit key
All Sites Cleared!
hit key
Do you want to
SAVE?
Duplicate name. Enter
another.
22
Table 2: Screen Messages
Power Up Messages
Contact the factory.
The backup battery that powers the non-volatile RAM has passed.
The DSP processor has passed.
The DSP RAM has failed. Contact the factory.
The DSP RAM has passed.
Record the EPROM sum at initial power up and periodically thereafter.
The NVR was automatically initialized due to a memory fault.
Contact the factory.
The non-volatile RAM has failed. Contact the factory.
The non-volatile RAM has passed.
Measurement Mode Messages
This message may appear during one of the following tasks:
1. clearing a log - there are no more logs to clear
2. logging data - user has hit
a new name
3. printing a log - there are no logs to print
4. displaying a log - there are no logs to display
Hit any key to resume taking measurements.
This message may appear during one of the following tasks:
1. saving a new site - a new site name was not entered or overwrite existing
site was not selected
2. recalling a site - there are no site files to recall
3. clearing a site - there are no sites to delete
4. printing a site - there are no sites to print
5. displaying a site - there are no sites to display
Hit any key to resume taking measurements.
This message appears upon exiting the User Program, if the new site data
has not been saved. Failure to save will result in loss of the new data next
time the site data is changed or recalled.
The site file or log name is already in use. Enter a different name.
Meaning
[ENT]
instead of selecting an old log or entering
DigitalFlow™ GS868 Service Manual