Advertisement
Align the caliper body halves then use a T25 TORX
4
each body bolt into the caliper two full turns.
Install the heat shield into the tabs, and make sure the heat shield is
pushed firmly flush against the caliper.
If the heat shield is not installed so that it is pushed against the caliper
wall, then it could interfere with brake performance.
Tighten each body bolt.
5
Remove the o-rings from the banjo bolt and banjo fitting.
6
Apply a small amount of SRAM® High-Performance DOT 5.1 brake fluid
to the new o-rings and install them.
®
wrench to thread
NOTI CE
T25
T25 TORX
SRAM DOT 5.1 brake fluid
20 mm or 15 mm Thru Axle
9.8 - 11.8 N·m (87 - 104 in-lb)
20 mm or 15 mm Thru Axle
Caliper Piston Installation
14
Advertisement
