Residual Risks; Symbols On The Appliance - Stanley FATMAX FMCR001 Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
Use your Stanley FatMax charger only
u
to charge the battery in the appliance/
tool with which it was supplied. Other
batteries could burst, causing personal
injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised Stanley FatMax Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The charger must be placed in a well
u
ventilated area when charging.

Residual risks

Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc. Even with the application of the
relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided.
These include:
Injuries caused by touching any
u
rotating/moving parts.
Injuries caused when changing any
u
parts, blades or accessories.
Injuries caused by prolonged use of a
u
tool. When using any tool for
prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing
u
dust developed when using your tool
6
(Original instructions)
(example:- working with wood,
especially oak, beech and MDF.)

Symbols on the appliance

The following symbols are shown on the
appliance along with the date code:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Do not attempt to charge
damaged batteries
The charger is intended for
indoor use only.
Electrical safety
#
Your charger is double insulated;
therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised Stanley FatMax Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. ON/OFF - Volume dial
2. Mode button
3. Set preset button
4. 1-6 Preset toggle button
5. LCD
6. Equalizer button
7. Clock button
8. Tune/Seek buttons
9. Antenna
10. AC plug
11. AC cord retainers
12. Charging indicator light
13. Battery port

Advertisement

Table of Contents
loading

Table of Contents