Operation (Standard Operation); Clamping / Aligning; Jaw Range; Servicing, Cleaning, Maintenance - WNT HDG2 Installation And Operating Instruction

________________________________________________________________________________________
4

Operation (standard operation)

4.1 Clamping / aligning

4.2 Jaw range

The reliable function of the clamping device is significantly affected by the selection of the
correct jaws.
5

Servicing, cleaning, maintenance

The HDG2 does not require special servicing since heavily used parts are protected against
soiling.

5.1 General cleaning / lubrication

Important: grease the front bearing of the mechanical force element with
bearing grease or Molycote at least once a week!
www.wnt.com
Align the vice on the slot table with longitudinal / cross
slots 20 H7 in the base plate, using the precision slot
nuts.
Items are clamped with three bolts through the base
plate or laterally with clamping claws.
 Remove locking pin and move out carriage.
 Do not remove any other parts.
 Clean the base plate and carriage.
 Lubricate the guides on a weekly basis, in the case
of heavy wear, twice a week, e.g. using MOTOREX
Supergliss 68 K lubricant to ISO VG 68.
 Place the carriage with the nut (pos. 30) upwards on
to a firm base.
 Turn the mechanical force element (pos. 80) anti-
clockwise up to the stop.
 Apply two to three grease pump actions to the
exposed grease nipple.
 Turn the mechanical force element clockwise until
the nut is approx. in the centre of the guide so that
the grease can spread.
 Regularly rinse the carriage from below with fresh
cooling water in order to remove surplus grease and
swarf.
XND.00004.023_A - 02/2018 20