General Safety Instructions; Intended Use; Technical Data; Reasonably Forseeable Misapplication - WNT HDG2 Installation And Operating Instruction

________________________________________________________________________________________
2

General safety instructions

2.1 Intended use

The clamping device may only be used in accordance with the technical data and has been
designed for stationary application on milling machines in an industrial environment.
Using the device in accordance with the intended purpose includes compliance with the
commissioning, installation and operating instructions, and with the environmental and
service conditions as provided by the manufacturer.
The manufacturer accepts no liability for damage resulting from non-intended use.

2.1.1 Technical data

Type max. Clamping force
HDG2 100
HDG2 125
HDG2 160
Weight:
HDG2 100:
HDG2 125:
HDG2 160:
For further data, please see the current WNT catalogue workpiece clamping

2.2 Reasonably forseeable misapplication

Any application that is not in accordance with the "Intended use" or exceeds such
intended use is considered not in accordance with the regulations, and is forbidden.
Any other use of the device is subject to confirmation from the manufacturer.
Examples of foreseeable misapplication:
 Clamping device used on rotating systems.
 Clamping widely protruding workpieces.
 Clamping workpieces with a weight of over 20 kg in vertical position
without an additional safeguard to prevent the item falling out.

2.2.1 Alterations and modifications

In the case of unauthorised alterations and modifications of the clamping device, the
manufacturer's liability ceases and any warranty is voided.

2.2.2 Spare and wear parts and auxiliary material

Only use original parts or parts approved by the manufacturer. Using spare and wear parts by
third party manufacturers may lead to risk.
www.wnt.com
30 kN
40 kN
60 kN
20.0 kg
27.0 kg
55.0 kg
XND.00004.023_A - 02/2018 16