Eaton Powerware 9140 Quick Start Manual page 17

5. Place the UPS on a flat, stable surface with the front of the UPS facing toward
you.
6. Remove the UPS front cover and the electronics module and set them aside
(see Figure 3):
To remove the UPS front cover, loosen the two front cover screws. Grasp the
fingergrips on both sides of the cover and pull the cover forward firmly.
To remove the electronics module, turn the module lock switch to the UNLOCK
position. Grasp the handle at the bottom of the module and pull the module
slowly out of the cabinet. Use two hands to support the module.
Figure 3. Removing the UPS Front Cover and Electronics Module
EATON Powerware
®
9140 UPS (7.5–10 kVA) Quick Start
INSTALLATION
S
164201678 Rev 1
5