Controls - Toro CM Series Operator's Manual

Controls

Become familiar with all of the controls before you start the
engine and operate the machine.
Engine Switch
When the engine switch on the cowl is in the R
it allows the engine to run. Moving the engine switch to the
S position shuts off the engine.
TOP
Handwheel
The handwheel controls the discharging action of the drum.
Drum-tilt Brake
The drum-tilt brake locks the drum into an upright position
or a discharging position.
Engine Controls
4
3
2
1
1. Recoil-start handle
2. Fuel valve
3. Choke lever
4. Throttle lever
Fuel Valve
The fuel valve (Figure 13) is located underneath the choke
lever. Move the lever for the fuel valve to the O
before attempting to start the engine. When you have finished
mixing, shut off the engine and move the fuel valve lever to
the O position.
FF
UN
5
7
8
Figure 12
5. Fuel cap
6. Dipstick
7. Oil-drain plug
8. On/Off switch
N
position,
1. Fuel valve
2. Choke lever
Choke Lever
Use the choke lever
pulling the recoil-start handle, move the choke lever to the
C position. Once the engine is running, move the
LOSED
choke lever to the O
engine is already warmed up or if the air temperature is high.
Throttle Lever
6
The throttle lever
engine. It is located next to the choke lever. It sets the engine
speed and therefore can increase and decrease the rotation
speed of the mixing paddles. For best performance, set this
control to the F
Engine On/Off Switch
Use the On/Off switch
G019744
engine. This switch is located on the front of the engine.
Rotate the On/Off switch to the O
the engine. Rotate the On/Off switch to the O
to shut off the engine.
position
1
1. Off position
14
1
2
G018792
Figure 13
3. Throttle lever
(Figure 13) to start a cold engine. Before
position. Do not use the choke if the
PEN
(Figure 13) controls the speed (rpm) of the
position when mixing material.
AST
(Figure 14) to start and shut off the
N
OFF
2
Figure 14
2. On position
3
position to start and run
position
FF
OFF
G021 103