Whirlpool 240-volt Use And Care Manual page 7

Installing the leveling legs
Leveling your dryer correctly will reduce
operating noise and provide improved drying
performance.
WARNING
Excessive Weight Hazard
Use two or more people to move and
install dryer.
Failure to do so can result in back or
other injury.
To install leveling legs:
1. Take two of the cardboard corners from
the carton. Place them on the floor in back
of the dryer.
2. Firmly grasp the body of the dryer. Gently
lay dryer on the cardboard corners.
3. Start to screw the legs into the holes by
hand. Use a wrench to finish turning the
legs. They should stick out about 1 inch.
4. Now stand the dryer up and move it close
to its final location. Leave enough room to
connect the exhaust vent.
5. Check levelness of dryer by placing a level
on top of the dryer, first side-to-side; then
front-to-back.
6. If dryer is not level, prop the dryer up
using two stacked cardboard corner posts.
Use a wrench to adjust the legs up or
down.
NOTE: It may be necessary to level the
dryer again after it is moved into its final
position.
INSTALLATION INSTRUCTIONS
7