Whirlpool 240-volt Use And Care Manual page 10

INSTALLATION INSTRUCTIONS
1. Disconnect power.
2. Remove hold-down screw and terminal
block cover.
3. Attach a 3 ⁄ -inch, U.L.-listed, strain relief to
4
the hole below terminal block opening.
Strain relief should have a tight fit with
dryer cabinet and be in a horizontal
position. Put the power supply cord
through the strain relief.
4. Loosen or remove terminal block screws.
Connect the neutral wire (white or center)
of power supply cord under the center
screw of the terminal block.
5. Connect the other two wires to outer
terminal block screws. Tighten all terminal
block screws firmly.
6. Tighten the strain relief screws.
7. Insert tab of terminal block cover into slot
of the dryer rear panel. Secure cover with
hold-down screw.
NOTE: If local codes do not permit the
connection of a frame-grounding conductor
to the neutral wire, see the instructions for
"Alternate Connection" later in this section.
10
Terminal block cover
External ground Center silver-colored
connector
terminal block screw
Neutral ground-
ing wire
(green/yellow)
3-Wire Connection with
Frame-Grounding Conductor
Hold-down screw
Neutral
wire
(white)
3 ⁄ ", U.L.-listed,
4
strain relief