Download  Print this page

Advertisement

DRYER INSTALLATION INSTRUCTIONS
Gas (U.S.A. and Canada) & Electric (Canada Only)
INSTRUCTIONS D'INSTALLATION DE LA SÉCHEUSE
Modèles de 29" et de 27" de largeur
À gaz (É.-U. et Canada) et Électrique (Canada uniquement)
Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite:
Tenga listo su número de modelo completo. Puede encontrar el número de modelo y de serie dentro de la cavidad superior de la puerta.

Table of Contents

DRYER SAFETY ................................................................
INSTALLATION REQUIREMENTS ....................................
Tools and Parts .................................................................... 4
Location Requirements ...................................................... 5
Electrical Requirements ..................................................... 7
Install Leveling Legs ........................................................... 7
GAS DRYER POWER HOOKUP ................................................. 8
Gas Supply Requirements .................................................. 8
Electrical Requirements ..................................................... 9
VENTING .................................................................................... 10
Venting Requirements ....................................................... 10
Plan Vent System ............................................................... 11
Venting Kits ........................................................................ 11
Install Vent System ............................................................ 12
Make Gas Connection ...................................................... 13
Connect Vent ..................................................................... 13
LEVEL DRYER ........................................................................... 14
COMPLETE INSTALLATION CHECKLIST ............................... 14
REVERSE DOOR SWING (OPTIONAL) .................................... 14
TROUBLESHOOTING ............................................................... 22
INSTALLATION NOTES
_________________________________
Date of purchase:
_______________________________
Date of installation:
________________________________________
Installer:
___________________________________
Model number:
___________________________________
Serial number:
W10115228B
W10115229B-SP
29" and 27" Wide Models
www.whirlpool.com
2
4
Table des matières
SÉCURITÉ DE LA SÉCHEUSE .......................................
EXIGENCES D'INSTALLATION ......................................
Outillage et pièces ............................................................ 25
Exigences d'emplacement ............................................... 26
RACCORDEMENT À L'ALIMENTATION ÉLECTRIQUE
DE LA SÉCHEUSE ÉLECTRIQUE - CANADA SEULEMENT ... 28
Spéci cations électriques ................................................ 28
Installation des pieds de nivellement .............................. 29
RACCORDEMENT D'UNE SÉCHEUSE À GAZ ....................... 29
Spéci cations de l'alimentation en gaz .......................... 29
Spéci cations électriques ................................................ 31
L'ÉVACUATION.......................................................................... 32
Exigences concernant l'évacuation ................................ 32
Plani cation du système d'évacuation ........................... 33
Trousses d'évacuation ...................................................... 33
Installation du circuit d'évacuation ................................. 35
Raccordement au gaz ....................................................... 35
Raccordement du conduit d'évacuation ......................... 36
RÉGLAGE DE L'APLOMB DE LA SÉCHEUSE......................... 36
ACHEVER L'INSTALLATION - LISTE DE VÉRIFICATION ....... 37
INVERSION DU SENS DE L'OUVERTURE DE LA PORTE
(FACULTATIF) ............................................................................. 37
DÉPANNAGE ............................................................................. 47
NOTES CONCERNANT L'INSTALLATION
_____________________________________
Date d'achat :
________________________________
Date d'installation :
______________________________________
Installateur :
________________________________
Numéro de modèle :
__________________________________
Numéro de série :
23
25
1

Advertisement

Table of Contents

   Also See for Whirlpool 29

   Related Manuals for Whirlpool 29

   Summary of Contents for Whirlpool 29

  • Page 1: Table Of Contents

    Gas (U.S.A. and Canada) & Electric (Canada Only) INSTRUCTIONS D’INSTALLATION DE LA SÉCHEUSE Modèles de 29" et de 27" de largeur À gaz (É.-U. et Canada) et Électrique (Canada uniquement) Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite: www.whirlpool.com...
  • Page 2: Dryer Safety

    DRYER SAFETY...
  • Page 4: Installation Requirements

    INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Tools needed for all installations: Adjustable wrench that Caulking gun and compound opens to 1" (25 mm) or (for installing new exhaust vent) hex-head socket wrench Flat-blade screwdriver #2 Phillips screwdriver Utility knife...
  • Page 5: Location Requirements

    Parts supplied: If you are using power supply cord, a grounded electrical outlet located within 2 ft. (610 mm) of either side of dryer. See “Electrical Requirements.” A sturdy oor to support dryer and a total weight (dryer and load) of 200 lbs. (90.7 kg). The combined weight of a companion appliance should also be considered.
  • Page 6: Dryer Dimensions

    The location must be large enough to allow the dryer door to open fully. Most installations require a minimum 5½" (140 mm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.” 29" Wide Models 27" Wide Models Dryer Dimensions Dryer Dimensions 23¾"...
  • Page 7: Electric Dryer Power Hookup - Canada Only

    ELECTRIC DRYER POWER GROUNDING INSTRUCTIONS HOOKUP – CANADA ONLY Electrical Requirements WARNING: SAVE THESE INSTRUCTIONS It is your responsibility: Install Leveling Legs To contact a quali ed electrical installer. To be sure that the electrical connection is adequate and in conformance with the Canadian Electrical Code, C22.1-latest edition and all local codes.
  • Page 8: Gas Dryer Power Hookup

    Gas type Screw in leveling legs Natural gas: This dryer is equipped for use with Natural Gas. It is design- diamond certi ed by CSA International for LP (propane or butane) gases marking with appropriate conversion. Your dryer must have the correct burner for the type of gas in your home.
  • Page 9: Electrical Requirements

    The gas pipe that comes out through the rear of your dryer has a 3/8" male pipe thread. 29" Wide Model 120 Volt, 60 Hz., AC only, 15- or 20-amp fused electrical supply is required. A time-delay fuse or circuit breaker is 1¼"...
  • Page 10: Venting

    VENTING Exhaust hoods: Venting Requirements Must be at least 12" (305 mm) from ground or any object that may obstruct exhaust (such as owers, rocks, bushes, or snow). Recommended Styles: Louvered hood Box hood Acceptable Style: WARNING: To reduce the risk of re, this dryer MUST BE EXHAUSTED OUTDOORS.
  • Page 11: Plan Vent System

    1-800-807-6777 or visit us at www.whirlpoolparts.ca. Part Number Descriptions 8171587RP 0–5" Metal vent periscope 4396037RP 0"–18" Metal vent periscope 4396011RP 18"–29" Metal vent periscope 4396014 29"–50" Metal vent periscope 4392892 In-Wall metal DuraVent™ Periscope W10186596 4-way vent kit – universal grey (27" Dryers Only) 4396028 Sure Connect™...
  • Page 12: Install Vent System

    Plan installation to use fewest number of elbows and turns. Vent System Chart When using elbows or making turns, allow as much room (29" Wide Long Vent Models Only) as possible. Number of Box/louvered, or Bend vent gradually to avoid kinking.
  • Page 13: Make Gas Connection

    Connect vent to exhaust hood Open shut-off valve Closed valve Open valve Open shut-off valve in supply line; valve is open when handle is parallel to gas pipe. Then, test all connections by brushing Vent must t over the exhaust hood. Secure vent to exhaust on an approved noncorrosive leak-detection solution.
  • Page 14: Level Dryer

    Not Level Not Level Tighten and adjust leveling legs If your door is the 29" Super Wide Side-Swing Door, follow steps 1–13. If dryer is not level, prop up using a wood block. Use wrench to adjust legs up or down, and check again for levelness.
  • Page 15 29" Wide Model Large Side-Swing Door Remove and transfer hinge hole plugs Place towel on dryer Use a small, at-blade screwdriver to gently remove 4 hinge hole plugs on left side of dryer cabinet. Insert plugs into hinge holes on opposite side of dryer cabinet.
  • Page 16 29" Super Wide Side-Swing Door Remove screws from hinges Place towel on dryer Remove screws attaching hinges to door. Place towel on top of dryer to avoid damaging the surface. Remove screws from door Remove bottom screws Remove screws at top, bottom, and side of door (4 screws).
  • Page 17 Flip door over Remove door strike Flip door over so handle side is down. Attach door hinges Remove door strike from dryer cabinet and set aside. Remove and transfer hinge hole plugs Use a small, at-blade screwdriver to gently remove 4 hinge hole plugs on left side of dryer cabinet.
  • Page 18 Remove door strike plug Remove bottom screws Open dryer door. Remove bottom screws from dryer cabinet side of hinges. Loosen (do not remove) top screws from dryer Remove door strike plug. Insert the door strike removed in cabinet side of hinges. Step 9 into hole and secure with screw.
  • Page 19 Remove screws from door Attach door hinges Remove screws at top, bottom, and side of door (5 screws). Keep door screws separate from hinge screws as they are different sizes. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door.
  • Page 20 Insert screws in hinge holes on Remove bottom screws dryer cabinet Open dryer door. Remove bottom screws from dryer cabinet side of hinges. Loosen (do not remove) top screws from dryer NOTE: 2 people maybe needed to reinstall door. cabinet side of hinges. Insert screws into the bottom holes on left side of dryer cabinet.
  • Page 21 Flip door over Rotate outer door Flip door over so handle side is down. Take outer door and rotate it 180º and set it back down on inner door. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel to inner door Remove screws from door panel so handle is on the side where hinges were just removed.
  • Page 22: Troubleshooting

    Remove door strike Remove door strike plug Remove door strike from dryer cabinet and set aside. Remove door strike plug. Insert the door strike removed in Step 10 into hole and secure with screw. Insert door strike Remove and transfer plugs plug into original door strike hole and secure with screw.

This manual is also suitable for:

2729" and 27" wide models

Comments to this Manuals

Symbols: 0
Latest comments: