Power And Signal Line Connections - Toshiba BMS-IFBN640TLE Installation Manual

BN interface
2

Power and signal line connections

 Cables
Use the following cable for signal line connections. (Procured locally)
No. Line
1 For TCC-LINK
2 For Ethernet
®
Ethernet is a registered trademark of Xerox Co., Ltd.
 Cable Connections
Connect the cables to the specified connectors.
Length of stripped TCC-LINK communication cable
Air conditioner
CAUTION
The TCC-LINK communication cable have no polarity.
* Secure the TCC-LINK communication cable and power cable to the switchboard etc. using the supplied cable tie to
ensure that no excess load is placed on the power cable connection and TCC-LINK communication cable connection.
-EN
8
Type 2-core shielded wires
Wire size 1.25 mm
Length 2.00 mm
LAN cable (higher than Category 5, UTP)
Type
The appropriate use of straight cable/cross cable should be done depending on your
®
system used
Length 100 m max.
Connect the supplied pin terminal to the TCC-LINK
50 10
communication cable as necessary.
The TCC-LINK communication cable must
be earthed on the air conditioner.
Do not connect the shield wire to the
connector. It should be open and
insulated.
Description
, 1000 m max.
2
, 2000 m max.
2
Connection of TCC-
LINK Communication
Cables
Installation Manual
total length
including air conditioner wiring length
Connect the
Connect the LAN
supplied power
cable
adapter