Swing Arm Installation; Motor & Trimmer Head Installation - Peco Z Trimmer ZT-3000 Operator's Manual

Swing Arm Installation

Position the Swing Arm (Item #5) to the front mount holes of the Pivot Block Assembly (Item #1). Place (1) 1/4" Flat
Washer (Item #4) between the Swing Arm and the Pivot Block Assembly on both sides. Refer to Figure A.
Secure the Lower Handle Assy by using (1) 5/16"-18 x 4" HHCS (Item #2) and (1) 5/16"-18 Ny-Flange Lock Nut (Item
#3). Leave fastener loose enough so that the Swing Arm will be able to pivot up and down freely.
Figure A
Motor & Trimmer Head Installation
Place the Motor (Item #1) into the Motor Mount (Item #2) and align the Head Shroud
(Item #3) under the Motor Mount Pivot and secure the Motor by using (2) 10-32 Hex
Nuts (Item #7). Refer to Figure B.
Place the Shaft Bushing (Item #6) onto the shaft of the Motor and use (1) 1/4"-28 x 1/4"
Set Screw (Item #8) to secure the Shaft Bushing. Once secured, position and install the
Trimmer Head (Item #4) and secure the Trimmer Head by using the Shaft Nut (Item #9).
After securing the Trimmer Head, close off the bottom of the Trimmer Head using the
Glide Plate (Item #5). Refer to Figure B.
Note: Some parts and features have been hidden from view for visual clarity.
Figure B
8
Note: Some parts and features have been hidden
from view for visual clarity.