Edging; Height Adjustment - Peco Z Trimmer ZT-3000 Operator's Manual

Trimming (cont.)
To activate trimmer head, lift the toggle switch cover and
flip the toggle switch forward. To de-activate the trimmer
head, push the toggle switch cover down. Refer to
Figure C.
Figure C
Toggle
Switch
NOTE: If the circuit breaker on the Z-Trimmer trips,
close the toggle switch cover, wait five seconds and
then push the reset button before turning on.

Edging

To position the trimmer head for edging, loosen the star
knob shown in Figure D, rotate the trimmer head into the
position desired for edging and re-tighten the star knob.
Figure D
Toggle
Switch Cover
Star
Knob
Rotate Trimmer
Head
Section 5 Height Adjustment
While in the down position, adjust the height of the
trimmer head so that it is in line with the blades on the
mower deck.
Figure A
Trimmer Head Is
Level With The Blades
For fine tuning adjustment of the height, use the
adjustment bolt shown in Figure B. Turn the bolt
clockwise to lower the swing arm, or counter-clockwise
to raise the swing arm.
Figure B
Adjustment
Bolt

Height Adjustment

Holes
11