Trimmer Line; Tips & Recommendations - Peco Z Trimmer ZT-3000 Operator's Manual

Section 6 Trimmer Line
To replace trimmer line, bend a new line into two equal
lengths, insert the line ends into the holes on the trimmer
head. The head will automatically route the line out the
correct hole. Pull each end taught and adjust if uneven.
Refer to Figure A. To order more trimmer line P#(ZT-
0017), contact PECO at (800) 438-5823.
Section 7 Tips and Recommendations
— Because the Z-Trimmer runs off your machine's charging system, it is recommended to operate the machine at full
throttle when using the Z-Trimmer.
— Inspect the Z-Trimmer before each and every use. Examine the base plate to ensure the Z-Trimmer is tightly
secured to your machine. Make sure the power cable is secure. Check all moving parts for damage or obstruction.
Inspect the trimmer head and line.
Check the head shroud for any debris before using the Z-Trimmer. Clean if necessary.
—
If the circuit breaker trips repeatedly, slow your speed and/or adjust your height setting.
—
— Keep your trimmer line in an easily accessible, but secure place on your machine. Practice replacing the trimmer
line from the operator seat to save time.
— If the Z-Trimmer gets hung up or caught on something, STOP and TURN THE POWER OFF before inspecting the
situation.
— Ensure the Z-Trimmer is in the correct angle (trimming/edging) and that the star knob is tightened securely before
use.
— Always inspect the area you are trimming before operating your Z-Trimmer. Look for anything that could potentially
get caught up in the trimmer head, or damage the trimmer.
12
Figure A Insert Line
Into Both Holes