Upper & Lower Handle Assembly; Lower Handle Assembly Installation - Peco Z Trimmer ZT-3000 Operator's Manual

Upper & Lower Handle Assembly
First, install the Power Switch (Item #4) by inserting it through the top mount hole of the Upper Handle Assembly (Item
#1). Position and place the Safety Cover (Item #5) over the Power Switch and using the Power Switch's knurl nut,
secure the Power Switch and Safety Cover. Refer to Figure A.
Next, position and mount the Circuit Breaker (Item #9) through the right mounting hole of the Upper Handle Assembly.
Then position the Electrical Cover (Item #3) in front of the Upper Handle Assy aligning the mounting hole with the
mounting bushing. Secure the Electrical Cover by using (1) 10-32 x 3/8" Pan Head Screw (Item #6).
Finally, position the assembled Upper Handle Assembly over the Lower Handle Assembly (Item #2) and secure both
Upper and Lower Handle Assembly by using (2) 1/4"-20 x 1/2" HHCS (Item #7) and (2) 1/4"-20 Nyloc Nuts (Item #8).
Fit the Handle Grip (Item #10) over the handle of the Upper Handle Assembly. Refer to Figure A.
Figure A

Lower Handle Assembly Installation

Position the Lower Handle Assembly (Item #1) to the lower rear mount holes of the Pivot
Block Assembly (Item #2).
Place (1) 1/4" Flat Washer (Item #4) between the Lower Handle Assy and the Pivot Block
Assembly on both sides. Refer to Figure B. Secure the Lower Handle Assy by using (1) 5/16"-
18 x 4" HHCS (Item #3) and (1) 5/16"-18 Ny-Flange Lock Nut (Item #5). Leave the fastener
loose enough so that the Lower Handle Assembly can freely pivot.
Note: Some parts and features have been hidden from view for visual clarity.
Figure B
Note: Some parts and features have been
hidden from view for visual clarity.
7