Seconique CORONA NEST OF TABLES Assembly Instructions, Care And Maintenance

Seconique CORONA NEST OF TABLES Assembly Instructions, Care And Maintenance

Hide thumbs Also See for CORONA NEST OF TABLES:

Advertisement

SEC/SH/10/19/MY3
53324(MY)

IMPORTANT

PLEASE READ BEFORE YOU CONTINUE FURTHER
After unpacking this product please keep the original packaging in case it needs to be
returned for any reason.
.
• Never drag or push products as this could cause damage to the joints making it inferior.
• Do not place this product next to a radiator or in direct sunlight.
if subjected to heat. Therefore it is recommended that room temperature is maintained,
• Make sure any spillage is wiped off immediately.
• Do not place hot or chilled items directly on to the surface, use a place mat or marking
will occur.
• For general cleaning use a duster, and do not use detergents of any kind. However, the
surface will need to be retreated from time to time. This can be done by using block wax
(unperfumed) and rubbing it over the whole item.
carried out.
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CORONA NEST OF TABLES and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Seconique CORONA NEST OF TABLES

  • Page 1 SEC/SH/10/19/MY3 53324(MY) IMPORTANT PLEASE READ BEFORE YOU CONTINUE FURTHER After unpacking this product please keep the original packaging in case it needs to be returned for any reason. • Never drag or push products as this could cause damage to the joints making it inferior. •...
  • Page 2 SEC/SH/10/19/MY3 325mm 270mm 215mm 280mm 560mm 420mm 215mm 270mm 325mm * Use of power tools to assemble this product will invalidate * Please check contents and read the instructions before commencing assembly. any claim and damage this product making it unsafe !!! * Assemble this product following the enclosed instructions carefully.
  • Page 3 SEC/SH/10/19/MY3 8 x 30 Glue must be added to the dowel holes on part GLUE 02, 03, 06, 07, 10 and 11 Large Table Glue must be added to the dowel holes on part 04 560mm 325mm 560mm 325mm 4,0 x 40 GLUE * For your future reference PO Number should be here...
  • Page 4 SEC/SH/10/19/MY3 Medium Table 420mm 270mm Glue must be added to the dowel holes on part 08 420mm 270mm 4,0 x 40 GLUE 3,5 x 35 Small Table 280mm 215mm Glue must be added to the dowel holes on part 12 280mm 4,0 x 40 215mm...

Table of Contents