Installation - Electrolux EMM20000 User Manual

12 www.electrolux.com
Problem
The appliance does
not operate.
The lamp does not
operate.
There is sparking in
the cavity.
There is sparking in
the cavity.
The turntable set
makes scratching or
grinding noise.
The appliance stop
to operate without a
clear reason.
9.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

10. INSTALLATION

WARNING!
Refer to Safety chapters.
10.1 General Information
CAUTION!
Do not block the air vents. If
you do that, the appliance
can overheat.
Possible cause
The door is not closed proper‐
ly.
The lamp is defective.
There are metal dishes or
dishes with metal trim.
There are metal skewers or
aluminium foil that touches the
interior walls.
There is an object or dirt be‐
low the glass cooking tray.
There is a malfunction.
Remedy
Make sure that nothing blocks
the door.
The lamp has to be replace.
Remove the dish from the ap‐
pliance.
Make sure that the skewers
and foil does not touch the in‐
terior walls.
Clean the area below the
glass cooking tray.
If this situation repeats call the
Authorised Service Center.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the appliance. Do not remove
the rating plate from the appliance.
........................................
........................................
........................................
CAUTION!
Do not connect the
appliance to adapters or
extension leads. This can
cause overloading and risk
of fire.
CAUTION!
The minimum installation
height is 85 cm.
• The microwave is for a kitchen
counter top use only. It must be
placed on a stable and flat surface.
• Put the microwave far away from
steam, hot air and water splashes.