Table of Contents
Advertisement
CHANGE OIL
The recommended Oil Change interval is 100 Hours of operating time.
1. Turn-off the Automatic Switch and unplug the Compressor from the electrical power
source.
2. Disconnect Air Line from Compressor Air Outlet.
3. Remove the Oil Drain Plug located at the lower front of the Crankcase (Fig 9) with a
5mm Hex Key (NOT INCLUDED).
4. Place a suitable container under the Drain Hole and allow the oil to run into it. It may
be helpful to place wedged under the wheels to allow the Compressor to tilt forward
slightly to aid in complete oil removal.
Used Oil is a polluting material and should
be disposed of in compliance with local regulations.
5. Replace Drain Plug and tighten securely with a 5mm Hex Key (NOT INCLUDED).
6. Remove the black plastic Oil Fill Plug from the upper right front corner of the Crankcase
(Figs 7 & 8).
7. Add a good grade of detergent free, SAE 30 Oil until the oil level is within the Red Dot of
the Sight Glass (Fig 6).
8. Replace Fill Plug
CLEANING AIR FILTER
It is important to clean the Air Filter every 100 Hours of operating time in normal conditions
and more frequently in the presence of sanding dust or other debris. The Air Filter Element is
of a permanent type designed for unlimited cleanings with no replacement necessary
1. Turn-off the Automatic Switch and unplug the Compressor from the electrical power
source.
2. Disconnect Air Line from Compressor Air Outlet.
3. Remove the two Socket Head Cap Screws retaining the Air Filter Housing to the Cylin-
der Head with a 5.5mm Hex Key (NOT INCLUDED) (Fig 10).
4. Remove the plastic Housing and separate the Filter (Fig 11).
5. Tap to remove any accumulation of dirt and debris then blow it out under low pressure
(approx. 40 PSI [3 bar]).
6. Re-install Filter to Housing and re-attach to Cylinder Head with Screws and tighten
securely (Fig 10).
To order parts and supplies: 800.345.1178 >> eastwood.com
FIG. 11
FIG. 9
FIG. 10
Oil
Drain
Air
Filter
7
Advertisement
Table of Contents
