Table of Contents
Advertisement
Step 8: Fasten the center support
Position the tray between the side plates by hanging them into the plates. Temporarily attach the right
end plate to the top plate with two 5/16" x 7/8" screws (see Figure 8). Swing the middle strut into posi -
tion and secure with 5/16" x 1" screws and Ø8
washer and 5/16" hex lock nut.
Not complete tighten.
1. Hexagon head screw 5/16" x 1"
2. Locking nut 5/16"
3. Central support
4. Spacer Ø8
Step 9: Attach the top compartment
Fasten both end plates to the top plate with 5/16" x 7/8" hex bolts, Ø8" washers and 5/16" hex nuts for
each corner (2 connections per corner). Repeat
these steps for each corner.
Do not tighten screws completely.
1. Hexagon head screw 5/16" x 7/8"
2. Locking nut 5/16"
3. Spacer Ø8
Step 10: Attach the Lifting Handle
Place the lifting handle through the large opening in the storage slot. Attach the lifting handle to the
smaller opening in the wheel holder using the 5/16" x 1-3
/ 16" screw and the 5/16" lock nut that you pre-assem-
bled in step 2. Attach the lifting handle to a larger hole
using a 5/16" x 1-3 / 16" hexagonal bolt, spacer and
5/16" hexagonal lock nut.
Tighten the connections firmly.
1. Hexagon head screw 5/16" x 1-3/16"
2. Locking nut 5/16"
3. Spacer
© by WilTec Wildanger Technik GmbH
Seite 24
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
