Table of Contents
Advertisement
Step 4: Fasten the end plates and the wheel holder
Start by turning the wheel holder in the middle of the axle shaft so that it points upwards. Next, attach
a side plate to one side, followed by a Ø20 washer and a wheel holder. Note that the wheel carrier ring
is facing inwards. Fasten the wheel bracket to the axle shaft with 1/4" x 1-9 / 16" hexagonal bolt and
1/4" counter nut. Tighten the connection firmly. Re-
peat
for the other side.
1. Side plate
2. Wheel holder
3. Screws 1/4"x1-9/16"
4. Locking nut 1/4"
Step 5: Attach the Wheel Assembly
Insert a 1/2" x 4-7 / 16" hex bolt through the wheel assembly, install the 1/2" hex nut onto the 1/2" x 4-
7 / 16" hex bolt and hand-tighten. Then loosen the hex
nut 1/2 turn. Attach the mounted wheel and screw the
1/2" x 4-7 / 16" hex to the wheel bracket and secure
with a 1/2" lock nut. Repeat for the other side.
Make sure that the wheels are turn freely after as-
sembly.
1. Wheel mounting
2. Hexagon head screw 1/2" x 4-7/16"
3. Hexagon nut 1/2"
4. Locking nut 1/2"
© by WilTec Wildanger Technik GmbH
Seite 22
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
