Table of Contents
Advertisement
Step 11: Adjust handle and tighten connections
Place the lawn aerator right side up on the wheels and lock the lifting handle into the offset at the front
of the storage slot. Perform the following steps to ensure correct alignment of the lifting handle with the
slot.
1. Adjust the compartment from side to side
so that the lifting handle rests on the
right side (seen from behind) of the off-
set on the front of the slot.
2. Align the side plates and then tighten the
eight screws at the corners of the com-
partment. Make sure that the lifting han-
dle is still on the right side of the slot off-
set.
3. Align the middle rail and tighten the two
screws that secure it to the tongue.
Make sure that the lifting handle is still on the
right side of the slot offset. You should bring the handle into alignment with the slot when lowering the
lawn aerator. The locking device is designed to help prevent the handle from slipping out when the
lawn aerator is in use. But if you feel that this part does not fit correctly, simply remove the pin.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 25
Advertisement
Table of Contents
