Table of Contents
Advertisement
TROUBLESHOOTING
Yes
Take an Ohm meter and
verify that the switch contacts
are opening and closing when
the switch lever is depressed.
Are they opening/closing?
Yes
Replace the
Replace the
Temp/Time
Controller
Microswitch
Problem
Solved
With no dough in the machine, adjust the thickness
adjustment so that with the handle closed the platens
are just touching each other. Does the alignment
between he upper and lower platens look even?
Take a folded rag or towel and place between he upper
and lower platens where they are touching each
other first. Lower the upper platen and apply some
handle pressure to attempt to bend the platens back
into alignment. Remove the towel, close the handle
and see if the alignment has improved. Repeat as
necessary until proper alignment is restored.
Timer Won't Count Down
Remove the rear cover. Does the
lower microswitch "click" when the
NO
Press is not Pressing Dough Evenly
Yes
area(s) as outlined in the owners' manual?
NO
Problem
Solved
machine handle is closed?
Are you pressing the dough in the
NO
Check the adjustment of the
switch so you can hear the
switch "click" when the
machine is closed.
Problem
Solved
NO
Review the instructions on
how to properly press dough
in the owners' manual for
your machine.
Problem
Solved
NO
Advertisement
Table of Contents
