Water Inlet; Water Drainage - Electrolux EWF1141AEWA User Manual

Loosen or tighten the feet to adjust the
level. A correct adjustment of the
appliance level prevents vibration, noise
and the movement of the appliance when
in operation.
counter clockwise "UP"
When the washing machine is levelled,
try to rock it from corner to corner. If it
does rock, adjust the legs again until it is
levelled and does not rock.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor. Install the machine on a flat hard
floor. Make sure that air circulation
around the machine is not impeded by
carpets, rugs etc.
Check that the machine does not touch
the wall or cupboard units.
clockwise "DOWN"

11.3 Water Inlet

Connect the water inlet hose to a tap
with 3/4" BSP thread.
Use the hose supplied with the washing
machine. DO NOT USE OLD HOSES.
check
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Loosen the ring nut to angle the hose to
the left or right depending on the position
of your water tap. Do not place the inlet
hose downwards. After positioning the
inlet hose, be sure to tighten the ring nut
again to prevent leaks.
35°
45°

11.4 Water Drainage

The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink,
using the plastic hose guide supplied
with the machine.
ENGLISH 37